Mix and Match Cables for CHIRP Transducers
Many CHIRP transducers are now made as Mix and Match
models. These versions have a common base transducer with an attached
9-meter cable, plus an interchangeable short (1-meter) brand-specific
adapter cable.
The permanently-attached 9-meter cable ends in an Airmar
12-pin connector. This cable is run up through the boat to the equipment
location. The short adapter cable connects to the transducer cable at
one end and to the equipment at the other end.
Both parts are needed for an installation. If the user
changes equipment brand at some later time, the transducer and its
attached cable can be left in place and only the adapter cable needs to
be replaced.
Note that CHIRP Mix and Match cables cannot be used with conventional 50/200kHz transducers.
The same cables are used for all CHIRP transducers
irrespective of their power rating.
Mix and Match Cables for CHIRP Transducers
Many CHIRP transducer..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transducer..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transducer..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transducer..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transducer..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transducer..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Mix and Match Cables for CHIRP Transducers
Many CHIRP transdu..
Brand: Airmar TechnologyCable-Length: 1 m (3')Country of Origin: USADisplay Connector..